Page 1
Product Information Packet Product Information Packet Product Information Packet Product Information Packet Product Name: Powerblast Product Name: Powerblast Product Name: Product Name: Powerblast Powerblast P P P P roduct Part Number roduct Part Numbers s s s : : : : 410414, 410416-410419,...
The care you give your Powerblast will greatly determine your satisfaction with its performance and service life. Careful study of this manual is encouraged to obtain a thorough understanding of your new Powerblast and its functions and maintenance.
• Unit is designed for training multiple offensive and defensive drills with proper technique. Do not use Powerblast for anything other than its approved purpose. • Always wear a helmet when training with the Powerblast.
Symbols Symbols Symbols Symbols Safety Alert: Precautions that involve your safety Store this equipment in a secure, controlled area: Unsupervised and/or inappropriate use of this equipment could result in serious injury. Pinch Point Symbol: Failure to keep hands away from pinch points will result in personal injury Stay Clear Warning Label: Stay clear of field equipment when it’s in use...
Rogers Athletic Field Equipment Specifications Rogers Athleti c Field Equipment Specifications Rogers Athleti Rogers Athleti c Field Equipment Specifications c Field Equipment Specifications Powerblast Powerblast Powerblast Powerblast Height (in) Width (in) Length (in) Weight (lbs) Powerblast 12 Arm 88 7/8...
Begin by setting runners roughly 50” apart, and slide the frame tubes onto the runners’ locator tubes. Attach the Powerblast arm carrier tubes with 5/8” u-bolts and nuts (15/16” wrench). Place them near the desired height before tightening.
Page 7
Remove Arms when not using and store out of direct sun. If your Powerblast is equipped with the hanging dummy, install it as shown with 1/2” dia U-bolts and nuts (15/16 wrench). Also attach the forward trolley stop with 5/8” bolts and nuts.
Page 8
Install the hanging dummy Trolley on the Trolley Runner as shown, with two wheels on top and one on bottom. Dummy can now be hung from the Trolley, and pads added to the sled. Finish assembly by installing the rear bump stop on the Trolley Runner. Use two 5/8 x 5” bolts and nuts.
Page 9
Optional Wheel Kit Install the wheel kit by placing the bracket over the runner tube with the wheels unlatched from the bracket and tighten pinch bolts (3/4” wrench). Repeat for each runner tube. LOCK UNLOCK Using the wheel kit: Lock the wheels in place by pushing down or standing on the wheel frame until the latch catches.
Customer Service Customer Service For parts or service contact Rogers Athletic Company. When ordering parts be sure to provide all relevant information available including the name and part number of the equipment purchased. This information is located on the cover of this product information package. Customer service hours are Monday through Friday from 8:00 a.m.
Page 11
Rogers Athletic Company 3760 N. Ludington Drive Farwell, MI 48622 www.rogersathletic.com (989) 386-2950 (800) 457-5337 Fax toll free (888) 549-9659 PIP410422...
Need help?
Do you have a question about the Powerblast and is the answer not in the manual?
Questions and answers