Location And Use Of Lower Latch Anchors; Location Of The Tether Anchor (Optional) - IC Bus CE Series Operation And Maintenance Manual

Seating and Safety Restraints
and the seat cushion. LATCH anchor locations may be identified
with the anchorage symbol just above the anchor.
Canadian school buses and all commercial buses must attach
the tether of the add-on child seat to the tether anchor located
on the passenger seat per the following instructions. To locate
the tether anchor (see Location of the Tether Anchor).
NOTE: Tethers are not required in U.S. school buses in
combination with child restraint anchorage system (UCRA)
when installing add on child restraint seats.
Passenger seats may have one or two child restraint anchorage
systems. If two anchor systems are present in the same
passenger seat, and only one add-on child seat is going to be
installed, it is recommended to use the system closest to the
wall to improve the mobility of the passenger in the open seat
in case of an emergency.
To prevent property damage, personal injury, and
/ or death, observe the following:
Follow all instructions on the child restraint
and in this manual. Follow the manufacturer's
warnings for proper use of the child restraint
system and LATCH attachments.
Follow the manufacturer's warnings for proper
use of the child restraint system and LATCH
attachments.
94
WARNING

Location and Use of Lower LATCH Anchors

1. Anchorage Symbols
2. Lower LATCH Anchors

Location of the Tether Anchor (Optional)

The tether anchor style and location may vary between seat
manufactures.
IC and CE White seats tether installation is as follows: