Regency BCTRC12048 Instructions

Hardware: A: Assembly Key B: Dowel Rod(4) C: Long Bolt(6)
D: Short Bolt(20) E: Locking Washer(20) F: Washer(20)
A
B
C
STEP 1a : Attach Bottom Stringer(I) to Leg(G1)
by inserting Rod into corresponding hole.
G1
STEP 1b : Secure Bottom Stringer(I) to
Leg(G1) with 2 Long Bolts(C) using Assembly
Key(A).
G1
C
IMPORTANT NOTICE:
● Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
● Check to be sure that you have all parts and hardware.
● Remove all wrapping materials, including staples & packing straps before you start to assemble.
● Do not tighten all screws/bolts until completely assembled.
● Keep all hardware parts out of reach of children.
BCTRC12048 • INSTRUCTIONS
You will need 2 person(s) for this assembly.
G1
D E
F
G2
I
I
Any problems or questions call Regency Office Furniture at 1-866-816-9822
Parts: G: Leg(2) H: Table Top(2) I: Bottom Stringer
J: Top Stringer K: Support(2)
H1
I
J
K
STEP 2a : Attach Top Stringer(J) by inserting
Rod(B) into corresponding hole on same Leg(G1)
as Bottom Stringer(I).
G1
STEP 2b : Secure Top Stringer(J) to Leg(G1) with
Long Bolt(C) using Assembly Key(A)
C
G1
STEP 2c : Repeat Step1a-2b for other Leg(G2).
H2
NOTE: Dowel Rod hole
for Top Stringer(J) is
below Long Bolt hole.
J
.
J