Advertisement
Operation and configuration
On initial power up, all status LEDs on the dimmer will illuminate green indicating
that the device has power. To set up this dimmer for use with a Control4 system,
refer to the Composer Pro User Guide.
To operate this dimmer as a stand-alone device prior to configuration in Composer
Pro:
•
If the light is off, click any button to turn the light on.
•
If the light is on, click any button to turn the light off.
•
Press and hold any button to ramp the light up/down. Release the button at
the desired light level.
•
If the split up/down buttons have been installed in the bottom button slot, the
up and down arrows will ramp and fade the light respectively.
Air gap switch
During routine lamp replacement, you should remove power from the lamp by
engaging the air gap mechanism. If using Contemporary faceplates, remove the
faceplate to access the air gap switch.
1
To engage, press on the right side of the top actuator bar until the left side
pops out. All LEDs on the dimmer will turn off and the dimmer will no longer
control the light when the air gap mechanism has been engaged.
2
To return power to the dimmer and lamp, press on the left side of the top
actuator bar until it snaps back into place.
Figure 3. Dimmer with actuator bar
Curved edge faces
top of keypad
Button tap sequences
The button tap sequences are defined in the table below. Button tap sequences
that require a single button should use the top button. Button tap sequences
requiring two buttons should use the top-most and bottom-most buttons installed
on the Keypad Dimmer.
Function
Identify
Zigbee channel
Reboot
Factory reset
Leave mesh and reset
Troubleshooting
If the light does not turn on:
•
Ensure that at least one LED on the face of the dimmer is lit.
•
Ensure that the light bulb is not burned out and is screwed in tightly.
•
Ensure that the circuit breaker is not turned off or tripped.
•
Check for proper wiring (see "Sample Wiring Configurations").
™
Actuator bar for
air gap switch
Button sequence
4
7
15
9-4-9
13-4-13
Care and cleaning
•
Do NOT paint the dimmer or its wall plate.
•
Do NOT use any chemical cleaners to clean the dimmer.
•
Clean surface of the dimmer with a soft damp cloth as needed.
Warranty and legal information
Find details of the product's Limited Warranty at
a paper copy from Customer Service at
such as regulatory notices and patent information, at
Sample wiring configurations
Figure 4. Single device location, with neutral connection (recommended)
Figure 5. Single device location, without neutral connection
snapav.com/warranty
or request
866.424.4489
. Find other legal resources,
snapav.com/legal
.
Advertisement
