About this guide
This guide provides instructions to install the Nortel Networks* BayStack* 380 10/100/1000
switch on a table or in an equipment rack. For more detailed information about the switch, refer to
Using the BayStack 380 10/100/1000 Switch (part number 212859-A).
This guide includes information about the following topics:
•
Environmental requirements for the installation site (next)
•
Installing the switch on a table
•
Network connection requirements
•
Connecting AC power
•
Descriptions of LEDs
•
Initial switch setup
Before you begin
Make sure the area where you will install and use the BayStack 380 Switch meets these
environmental requirements:
•
Ambient temperature between 41° and 104° F (5° and 40° C)
•
Relative humidity between 5% and 85% noncondensing
•
No nearby heat sources such as hot air vents or direct sunlight
•
No nearby sources of severe electromagnetic noise
•
No excessive dust
•
Adequate power source within six feet; one 15-Amp circuit required for each power supply
•
At least 2 inches (5.08 cm) on each side of the switch unit for ventilation.
•
Adequate space at the front and rear of the switch for access to cables.
If you are installing a single BayStack 380 Switch on a table or shelf, make sure the surface will
support at least 5 to 10 pounds.
Note: The direction of air flow in the BayStack 380 switch is from left to right.
(page
5) or in a rack
(page
(page
9)
(page
9)
(page
11)
(page
6)
7)
Installing the BayStack 380 10/100/1000 Switch
3