Power Management; Screen Blank State; Putting The Computer To Sleep Or Shutting It Down; Putting Your Computer To Sleep - Lenovo V14 Hardware Maintainence Manual

Lenovo V14 and V15 Hardware Maintenance Manual

Power management

Screen blank state

Putting the computer to sleep or shutting it down

Putting your computer to sleep

24
Note: Power management modes are not supported for APM operating system.
To reduce power consumption, the computer has three power management
modes: screen blank, sleep (standby), and hibernation.
If the time set on the "Turn off monitor" timer in the operating system expires,
the LCD backlight turns off. You can also turn off the LCD backlight by
pressing
.
To end screen blank state and resume normal operation, press
.
keyboard
When you have finished working with your computer, you can put it to sleep or
shut it down.
If you will be away from your computer for only a short time, put the computer
to sleep.
When the computer is in sleep mode, you can quickly wake it to resume use,
bypassing the startup process.
To put the computer to sleep, do one of the following:
• Close the display lid.
• Press and hold the Power key for about 1 to 5 seconds.
• Move the cursor to the lower-left corner, and then select the Start
button. Select Power
Note: Put your computer to sleep before you move it. Moving your computer
while the hard disk drive is spinning can damage the hard disk, causing
loss of data.
To wake up the computer, perform the following:
• Press any key on the keyboard.
→ Sleep.
any key on the