Install The Pcie-Poe354At Frame Grabber Card - Neousys Technology PCIe-PoE354at User Manual

3.4

Install the PCIe-PoE354at Frame Grabber Card

PCIe-PoE354at utilizes the x4 PCI Express bus to communicate with the host computer.
Before you install the PCIe-PoE354at, please make sure that there is a x4 PCI Express slot
available on your host computer.
Note
Most modern computers have x16 PCI Express slot(s) for installing a graphics card. It can be
possibly configured as a PCI Express Root Port for installing a general PCI Express card. Please
contact the vendor of your computer to check if PCIe-PoE354at can be fitted into your x16 PCI
Express slot.
You can install the PCIe-PoE354at frame grabber card by following the steps listed below.
1. Configure Board ID if necessary according to section 3.1.
2. Configure 12 VDC source if necessary according to section 3.2.
3. Open the chassis of the host computer and expose the x4 PCI Express slot (or a
compatible x16 PCI Express slot).
4. Align and insert the golden-finger connector of PCIe-PoE354at into the PCI Express
slot until it's firmly contacted.
5. Fix the PCIe-PoE354at to the host computer using with a screw.
Copyright © 2015 Neousys Technology Inc. All Right Reserved.
PCIe-PoE354at/PCIe-PoE352at User's Manual
Page 14 of 31