Fitting And Adjusting The Carrying System; Balancing The Brushcutter - Stihl FSA 135 R Instruction Manual

8 Adjusting Trimmer for User
► Move the loop handle (1) to the required position and
check that the following conditions are met:
– The bump guard (3) fits between the loop handle (1) and
carrying ring.
– If you are using a mowing head: a = no more than 30 cm
– If you are using a metal cutting attachment: a = no more
than 25 cm
► Tighten down the screws (2) so that the loop handle (1)
cannot be rotated on the shaft.
8.2

Fitting and Adjusting the Carrying System

1
2
► Put on the shoulder strap (1) or full harness (3).
► Adjust the shoulder strap (1) or full harness (3) so that the
carabiner (2) is about a hand's width below your right hip.
Other approved carrying systems are listed in this User
Manual, @ 21.
0458-662-0121-A
8.3
The cutting attachment should rest lightly on the ground.
► Switch off the brushcutter and remove the battery.
3
2
► Connect the carrying ring (2) to the carabiner (1).
► Wait for brushcutter to stop swinging.
Check the position of cutting attachment. If it needs
adjustment:

Balancing the Brushcutter

English
1
2
19