C) Resetting The Speed Controller - Reely 2103650 Operating Instructions Manual

c) Resetting the speed controller

Use this function to reset all configured settings to the factory defaults (see grey markings in the table in chapter 9. b).
Proceed as follows:
• Switch on the remote control. Leave the throttle/brake lever in the neutral position, do not move it.
• Turn on the speed controller (briefly press the on/off but-
ton (A)). Wait until the speed controller has completed
its self-test and the LEDs (C) on the speed controller
stop flashing / glowing.
The speed controller must not be in program-
ming mode.
• Now hold down the Setup button (B) (do not let go).
• The red and green LED (C) on the speed controller
flashes slowly at the same time.
• If the green LED flashes and you hear short beeps, re-
lease the Setup button (B).
• The speed controller has been reset to the default settings, see table in chapter 9. b).
Important!
After a reset of the speed controller, you must first program the neutral and full throttle positions, as de-
scribed in chapter 9. a).
You can then change the default settings as described in chapter 9. b), if desired.
If a LiPo battery is used to drive the motorcycle, the low voltage protection must be activated. If low voltage
detection is switched off, the LiPo battery may be permanently damaged due to overdischarge.
43