Programming The Speed Controller; A) Adjusting The Neutral And Full Throttle Setting - Reely 2103650 Operating Instructions Manual

9. Programming the speed controller

a) Adjusting the neutral and full throttle setting

If the vehicle does not stay stationary when the throttle/brake lever is in the neutral position, the throttle trim can be
adjusted on the transmitter. If the trim path is insufficient (or if the trim is almost at the end of the trim path), you can
reprogram the neutral position and full throttle for forward drive or brake function. Do not reach into the drive during
programming!
Proceed as follows:
• Switch on the transmitter, leave the throttle/brake lever in the neutral position. Set the trim for the drive function to
the neutral position. The "TH.REV" slide switch of the included transmitter must be pushed upwards (in the direction
of the "TH.REV" inscription).
• Turn off the speed controller by pressing and holding
down the on/off button (A) for more than 0.5 seconds.
The red LED in the on / off button goes out.
• Keep the setup button (B) pressed and turn on the
speed controller by briefly pressing the on/off button (A).
• The red LED (C) on the speed controller will then flash
and the motor will emit beeps. Release the setup but-
ton.
Beeps are generated by a brief activation of the
motor.
• Release the throttle/brake lever on the remote control
so that it is in the neutral position.
• If you press the setup button (B) briefly, the green LED on the speed controller will flash once briefly and you will
then hear a beep. The neutral position has been saved.
• Move the throttle/brake lever on the transmitter to the full speed throttle position, then pull it as far as it will go in the
direction of the handle and hold it there.
Caution!
If you do not move the throttle/brake lever on the transmitter or do not move it far enough during program-
ming, the vehicle may respond to even minute movements of the throttle/brake lever on the transmitter or
become uncontrollable upon completion of programming. In this case, reprogram it.
• If you press the setup button (B) briefly, the green LED on the speed controller will flash twice briefly and you will
then hear two beeps. The full forwards throttle position will be saved.
• Move the throttle / brake lever to the brake position, push it away from the handle until it stops.
• If you press the setup button (B) briefly, the green LED on the speed controller will briefly flash three times and you
will hear three beeps. The braking position is stored.
• Release the throttle/brake lever to return it to the neutral position. Wait for at least three seconds. The speed con-
troller will exit settings mode and apply the new settings.
40