Required Clearance; Mounting The Device - Siemens SIMATIC IFP2200 Product Information
Hide thumbs
Also See for SIMATIC IFP2200:
- Operating instructions manual (120 pages) ,
- Compact operating instructions (47 pages) ,
- Product information (29 pages)
Table of Contents
Advertisement
Available languages
Available languages
Required clearance
The following clearance is required for sufficient self-ventilation around the device:
•
At least 10 mm to the right and left of the mounting cutout (in x direction)
•
At least 10 m above and below the mounting cutout (in y direction)
•
At least 10 mm behind the rear panel of the device (in z direction).
The figure below shows the required clearances when the device is installed in landscape and portrait format:
①
Clearance for mounting in landscape format
②
Clearance for mounting in portrait format
x
At least 10 mm distance
y
At least 10 mm distance
z
At least 10 mm distance
Note
Ensure that the permitted ambient temperature is not exceeded when mounting the device in a cabinet and especially in a
closed enclosure.
Mounting the device
Installation guidelines
NOTICE
Damage to the device due to the open front
The frameless front does not have a protective enclosure. Electrostatic-sensitive components are destroyed on contact with
wires. The front can warp when shear forces are applied. This can result in damage to the machine or system.
•
Observe the safety information on ESD guidelines.
•
Do not expose the front to mechanical stress, e.g. during installation.
•
Ensure adequate sealing during installation.
•
Higher degrees of protection of the device front can only be guaranteed if the mounting seal is intact and lies flush
against the mounting cut-out.
•
To guarantee a higher degree of protection, you need to take suitable measures yourself. With correct installation, IP65
can be reached.
•
Observe the minimum thickness of the enclosure (material thickness): Height of threaded sleeve = 5.5 mm.
•
Observe the length of the M3 screws: Maximum screw-in depth into threaded sleeve = 5 mm.
Note CAx data
The CAx data for electrical planning (circuit diagrams, data sheets, ePlan macros), for example, are available from the
underlying standard devices. A description of how to obtain this data can be found on the Internet: CAx Download
(https://support.industry.siemens.com/cs/us/en/view/89671877)
20
SIMATIC IFP2200/2400 ITC2200/2400 frameless
A5E48015893-AC, 03/2021
Advertisement
Table of Contents
