Desa Proflame 584 Quick Start Manual

ProFlame 584 GTm rePlacemenT KiT
This proflame remoTe sysTem is a direcT replacemenT for The original remoTe included wiTh your
comforT glow model lmfp fireplace sysTem or models ldl 24" and 30" log seTs
Kit contains:
1 - Proflame GTM Receiver
1 - Proflame GTM Transmitter
1 - Proflame Wire Harness
1 - Receiver Cover with 2 screws
1 - Mounting Bracket (for LDL log sets only) with 2 screws
to mount receiver to bracket

disconnecTing exisTing proflame componenTs

1. Turn unit off and allow to cool.
2. for ldl log sets: To access receiver, remove left front crossover log
and left front log.
for lmfp fireplace: Receiver is located in compartment behind bottom
louver.
3. Remove batteries from receiver and hand transmitter. Set aside for use
in new remote system. Use new batteries if you are unsure of battery
life.
4. Disconnect stepper motor cable from connection labeled "motor" on
receiver (see Figure 1).
5. Disconnect red and black wires from the TH and TPTH connection at
control valve. Leave red and white wire from thermopile connected (see
Figure 2).
Motor
Connection
Black
Red
Figure 1 - Receiver Connection
Figure 2 - Valve Connection

preparing new proflame componenTs

1. Remove replacement receiver and hand transmitter from kit. Install 3 AAA
batteries from old hand transmitter. Be sure to orient positive and negative
on batteries as shown in Figure 3.
2. Place 4 AA batteries into receiver as shown. Be sure to orient positive
and negative on batteries as shown in Figure 3.

for ldl log seTs

1. Remove old bracket from LDL chassis. Keep screws for step 4.
2. Insert new receiver through opening in bracket provided with this kit. Use
3. Secure receiver cover to receiver with two screws provided with cover.
4. Secure receiver assembly to LDL chassis using existing screws removed

for lmfp fireplaces

The receiver can lay loose in the control valve area with no bracket. Position
receiver to the front of fireplace, facing forward.
Disconnect
Black and
Red Wires
from Valve
Receiver
Cover
Save for future reference.
For more information, visit www.desatech.com
Battery
Housing
Cover
Receiver
Battery
Housing
Cover
Screws
Figure 3 - Battery Installation
2 screws from kit to secure receiver to bracket.
in step 1 (see Figure 4).
Receiver
Bracket
Receiver
2
Figure 4 - Receiver and Bracket Assembly
Bottom
of Hand
Transmitter
(Remote
Control)
-
AAA
+
-
AAA
+
-
AAA
+
AA Batteries
Cover Plate
3
1