Advertisement
Electrical Connections
This appliance is fitted with a fused three-pin plug to BS 1363. If the plug has
to be removed, it should be cut off and carefully disposed of immediately. To
avoid a possible shock hazard, do not insert the discarded plug into a mains
socket.
Fitting a new plug
The mains lead must be connected as shown below. The wires are coloured
with the following code - Brown wire = Live (L), Blue wire = Neutral (N),
Green & Yellow = Earth (E).
The Blue wire must be connected to the terminal marked N or coloured Black.
The Brown wire must be connected to the terminal marked L or coloured Red.
The Green and Yellow wire must be connected to the terminal marked E or
coloured Green.
Check that there are no cut or stray strands of wire inside the plug.
Use a 13 Amp BS 1362 fuse, only use BSI or ASTA approved fuses.
If you are in any way unsure which plug or fuse to use, always refer to a
qualified electrician.
After replacing or changing a fuse on a moulded plug, the cover must be refitted
to the plug; the appliance must not be used without a fuse cover.
WARNING: Do not wrap the cord around the heater for storage.
Connect
Green &
Yellow to
Earth (E
)
Connect
Blue to
Neutral (N)
Connect
Brown to
Live (L)
Ensure the outer sheath of the mains
lead is securely held by the cable clamp
Advertisement
