Advertisement
5. Re-attach the heater to the wall bracket.
NB This Mini Convector Heater must not be permanently wired to the mains.
Operating Your Mini Convector Heater
1. Insert the mains plug into the nearest mains socket.
2. Press the On/Off switch at the bottom right hand side to the on position
by pressing 'I', the switch will illuminate to show the unit is powered up.
3. Rotate the Thermostat clockwise to increase the room temperature,
rotate anticlockwise to decrease the temperature.
4. The heat indicator lamp will go on and off during use to show that the set
temperature is being maintained – this is quite normal.
Frost Protection
This heater is fitted with an Anti-Frost device, this operates the heater
automatically when the room temperature drops below 10˚C.
Note: The Anti-frost function operates when the thermostat is set to the
lowest level.
Hint on setting the correct temperature
1. Set the heater to the desired heat setting as above.
2. Rotate the Thermostat to the maximum position and allow the room to
warm up. Once the desired room temperature has been reached turn
the Thermostat anticlockwise until the heater just clicks off then turn it
back up clockwise very slightly. The Thermostat will now maintain the
room temperature, if necessary, further increasing or decreasing the
thermostat control may be required to 'fine tune' the ideal room
temperature.
Care and Use of your Mini Convector Heater
Always disconnect the heater from the mains power supply before cleaning.
Clean outside of the heater with a clean damp cloth. Never clean with harsh
or abrasive cleaners.
Do not submerge any part of heater in water or any other liquids.
Technical Data
Voltage
Rated power
Model Number :
:
220-240V AC 50Hz
:
450 W
HEA1187
Advertisement
