Vermeer BC1000XL Operator's Manual page 27

(3) Hold-to-Run Button (Located on both sides of feed table)
Press briefly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . feed roller operates
and Lower Feed Stop Bar is ignored for one second.
Press and hold. . . . . . . . . . . . . . . . . . . . . . . . . . feed roller operates
for a maximum of 30 seconds regardless of position
of Upper Feed Control Bar (1) and Lower Feed
Stop Bar (2). After 30 seconds, feed roller stops.
(4) Lower Feed Stop Bar Sensitivity Switch (BC1000XL
Units Only)
Press top . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Normal sensitivity
NOTE: Feed roller stops when stop bar is pushed a shorter distance
Press bottom . . . . . . . . . . . . . . . . . . . . . . . . . . . . Reduced sensitivity
NOTE: Feed roller stops when stop bar is pushed a farther distance
NOTE: Each time engine key is turned OFF, the lower feed stop bar system
defaults to the "Normal Sensitivity" selection.
BC1000XL Brush Chipper 3_06 3_01
3
4
Controls 20-7