Advertisement
Note: Screws, plates and cables will be used again. Do not throw them away.
Fig.2: Inside of the AT-1575 (Before replacement of the board)
2.
Check the version of the Board.
3.
Disconnect the wires from TB5.
4.
Unfasten the screw on TB4 (M4x6), then disconnect the shield cable.
5.
Unfasten the washer head screws (M3x12), then remove clamp4.
6.
Disconnect the coaxial cable from TB1.
7.
Unfasten the washer head screw (M3x8,10pcs.,indicated in figure above) and remove the
protection plate (05-106-3707-0) from the board.
8.
Unfasten the screw on TB2 (M4x6), then disconnect the wire assembly (Type AF).
9.
Unfasten the screw on TB3 (M4x6), then disconnect the transmission cable.
10. Disconnect the cables from J1 and J2 connectors.
11. Remove the cables from Clamp 2 and Clamp 3.
12. Remove the cable from Clamp 1.
Washer Head Screw (M3x8, 10 pcs.)
TB3
Clamp1
J2
Clamp2
Version of the Board
TB5
TB4
Clamp3
Protection
plate
Clamp 4
TB1
J1
Coaxial Cable
2
TB2
Advertisement
