glass 1989 MYSPA 195 E Installation, Operation & Maintenance Manual page 20

EN
compartment with the jet pump on for at least ten minutes.
step is important, as out-of balance TA will affect your ability
to adjust the pH correctly and will prevent the sanitizer from
operating effectively.
chlorine (sodium dichlor) per 950 liters (250 gallons) of spa
middle position.
the next step.
"JETS" twice on the control panel, this will
and 5 ppm, go on to the next step. If the residual is less than 3
of chlorine (sodium dichlor) per 950 liters of spa water, while
to circulate the spa water.
OPERATION NOTE: Make sure you adjust your Total
your ability to adjust the pH correctly, and will prevent the
sanitizer from operating effectively. The spa is ready for use
when the spa water has circulated and the chlorine level
remains between 3 ppm and 5ppm.
OPERATION NOTE: For proper water circulation during the
ten minute automatic clean cycle the following steps should
be performed.
AIR
OFF
CAUTION: ENTER THE TUB SLOWLY TO GIVE THE EXCESS
WATER TIME TO DRAIN AWAY INTO THE PERIMETER
DRAINAGE CHANNEL OF THE SPA.
"JETS" twice on the control panel,
"JETS" twice on the
ON
Do not use the spa the FIRST TIME it is STARTED UP
after super chlorination, given the high concentration of
disinfectants in the water at this time. Completely drain the
alkalinity otherwise it will be impossible to adjust the pH
correctly and disinfection will not be carried out properly.
The spa will only be ready for use after the water has been
circulated and the chlorine level in the water is between 3
and 5 ppm.
IMPORTANT: pour the chemical products directly into the
speed jets for at least ten minutes.
WINTERIZING YOUR SPA
PUMP DRAIN PLUG LOCATION
DISCHARGE
UNION
PUMP PLUG
If you wish to leave your spa empty and it is located where
freezing temperatures occur, follow steps outlined in "Draining
Your Spa", then complete the following steps:
IMPORTANT: The following steps should protect your spa
from freezing damage provided these instructions are
followed exactly. For maximum protection against freeze
damage to your spa, Manufacturer recommends contacting
your local dealer to schedule an in-home Propylene glycol
(anti-freeze) Winterizing Service plan.
NOTE: MAKE CERTAIN ALL POWER TO THE SPA IS OFF
BEFORE YOU CONTINUE.
the following steps:
and store in a dry place.
2. Thoroughly dry the spa shell with a clean towel.
CAUTION: Use only Propylene glycol as your anti-freeze. This
is non-toxic. NEVER use automobile anti-freeze since it is toxic.
4. Close the spa cover and fasten the cover tie downs. If your
area recieves a lot of snow or ice, it is recommended to cover
the spa cover with two pieces of plywood forming a pitched roof
or tarp over the spa cover and one over the plywood.
WARNING: When not in use, the spa must be covered with an
insulating spa cover. Damage caused by either sun exposure
or freezing is not covered under warranty.
the door screws. Once doors are removed unscrew the pump
drain plugs located on the front of the pump housings. Allow all
20
SUCTION
UNION