glass 1989 MYSPA 195 E Installation, Operation & Maintenance Manual page 18

EN
pH, and other water care requirements.
schedule, and in accordance with this owner's manual.
spa water system.
SPA LEVELING PREPARATION (MySpa 195_E)
Concrete sloped at 1.3 cm per 3 m is preferred so that rain water
and water spillover will run off and not puddle underneath the spa.
to note that soft surfaces, even when stepping stones are used
to settle, thus resulting in an unleveled spa.
NOTE: Placing the spa on grass or dirt may increase the amount
may cause harm to your equipment as well as the spa surface,
which is not covered under warranty.
3 m (10 ft.) = Slope 1.3 cm (1/2 inch) per 305 cm (10 ft.) for
proper drainage.
CAUTION: adjust the central feet of MySpa to ensure that
SPA COVER INSTALLATION
NOTE: Keeping the cover in place any time the spa is not
in use will reduce the amount of time the heater operates,
thereby minimizing operating costs.
DANGER.RISK OF INJURY.
1.3 cm
installation set-up).Connecting the spa to an improperly wired
circuit will negate many of the spa's safety features. Improper
0
16 amp, single phase, 220-230 volt, three wire service (one line,
longer than the phase and neutral conductors. If a stationary
other means for disconnection from the supply mains having
a contact separation in all poles that provide full disconnection
under overvoltage category III conditions, the instructions shall
WARNING: Removing or bypassing any GFCI breaker will
result in an un safe spa and will void the spa's warranty.
IMPORTANT:
your spa, it is essential
that you understand and apply these installation requirements.
an improperly wired circuit will negate many of its safety features.
CONDUIT INSTALLATION INSTRUCTIONS
the installation systems compartment.
cover.
18
C.V. (see