Additional Information; Troubleshooting - Ya-man Cavi Spa 360 User Manual

Additional Information

Troubleshooting

If you perceive any abnormality while using the device, verify the following points before arranging to have the device repaired.
Symptom
Does not turn on
The device shuts o
(Device only operates for a
few minutes even after charging)
Unable to charge or charging
lamp is not ashing
Ultrasonic wave electrode is hot
Ultrasonic waves vibration
(cavitation) is not felt.
Unable to change the level of ultrasonic waves
The device buzzes during use
Possible Causes and Solutions
Press the POWER/MODE button for approx. 3 seconds.
Run out of power. Charge the battery (page 12).
It is charging. Remove the AC adaptor.
Charging is insu cient. Charge the device for approx. 3 hours.
The auto-o timer was activated (page 10).
Insert the AC adaptor into the charging terminal of the device and outlet rmly to its end.
Charging has been completed. When charging is completed, the mode lamps (
The electrode has become warm due to the vibration of ultrasonic waves.
If the device is too hot, turn o the switch. In approx. 10 minutes, turn on the switch again.
Ultrasonic waves (cavitation) generate very little vibration, so you do not feel them.
(Ultrasonic waves will not be generated for the Face mode.)
The level of ultrasonic waves cannot be adjusted.
It is the sound of the vibration of ultrasonic waves. There is no problem.
/ ) will turn o .
24