Programming The Remote Control - Apex Digital AT3208S Instruction Manual

Instruction Manual
FUNCTIONS & FEATURES (continued)

Programming the Remote Control

1. Set the TV, DVD/VCR,SAT/CAB, AUX switch to the device you want to control.
2.To program the remote control
1)Press and hold the SET key for over 3 seconds until the LED indicator on the remote control turns off.
Release the key and the LED will light again. The remote control is now in the PROGRAMMING mode.
2)Use the 0-9 keys to enter three-digit code number for your device. If the right code number was entered,
the LED blinks three times. If you enter a code not listed below, or you press any other keys than
STANDBY and ENTER, the LED turns off.
3)"TV": To control TV. "DVD/VCR": To control DVD, VCR, LD and CD. "SAT/CAB": To control satellite
receiver and cable box. "AUX": To control all the above appliances.
3.To search codes
1)Press and hold the SET key for over 3 seconds until the LED indicator on the remote control turns off.
Release the key and the LED will light again. The remote control is now in the PROGRAMMING mode.
2)Press the STANDBY key and code search begins.
3)
Press
The remote control searches codes upwards or downwards. Each time you press the up or
down arrow key, the code number for the STANDBY key increases or decreases by 1; or the
up or down
code number automatically increases or decreases by 1 per 3 seconds. Try each code
arrow key
separately until you find the one that works. If not after trying all the codes, LED blinks rapidly
eight times and search stops.
If the desired code number is found, press the ENTER key to confirm the current searched
ENTER
code number for your device. Then LED blinks rapidly three times to exit from search.
Other keys LED blinks rapidly eight times and search stops.
4)When the TV, DVD/VCR, SAT/CAB, AUX switch is set to the "AUX" position, the remote control can not
search code.
4.To check the current code number
1)Press and hold the SET key for over 3 seconds until the LED indicator on the remote control turns off.
Release the key and the LED will light again. The remote control is now in the PROGRAMMING mode.
2)Press the ENTER key.
3)You may read the code number according to the LED display status as follows.
Code Number
First-digit Second-digit Third-digit First-digit
0 0
1 0
0 4
1 5
5.To use the REC key
The REC key functions only when it is pressed twice continuously.
0 Blinks rapidly once Blinks rapidly once Blinks rapidly once
6 Blinks once
3 Blinks rapidly once Blinks four times
0 Blinks once
13
Description
LED Display Status
Second-digit
Blinks rapidly once Blinks six times
Blinks five times
Third-digit
Blinks three times
Blinks rapidly once