Programming The Remote Control - Apex Digital PF2425 Instruction Manual

ADDITIONAL FEATURES
Programming the Remote Controller
Remote - controIIer switchover
Press the TV, VCR/DVD, SAT/CAB or AUX button to seIect the device you want to controI.
To program the remote controller
Press and hoId the TV, VCR/DVD, SAT/CAB or AUX button for over 2 seconds until the lNDlCATOR on the
remote controIler turns off (the remote controIIer enters the PROGRAMMlNG mode).
Use the 0 - 9 buttons to enter three - digit code number for your equipment. lf the correct code number is
entered, the INDICATOR bIinks three times. If you enter a code not listed beIow, or you press any other
buttons than SEARCH and 100 +, the lNDICATOR turns off.
To search codes
Press and hoId the TV, VCR/DVD, SAT/CAB or AUX button for over 2 seconds until the INDICATOR turns
off. ReIease the button (the INDICATOR wiII light again) and the remote controIIer enters the PROGRAM-
MING mode.
Press the SEARCH button.
Press the - CH + buttons to search codes downwards or upwards. Each time you press the - CH + but-
tons, the code number decreases or increases by 1 whiIe the remote controIler sends the code number for
POWER button on your device.
lf the desired code number is found, press the 100 + button to program the code for your device until the
lNDICATOR bIinks three times. Then the remote controIler exits from the PROGRAMMING mode and returns
to normal operation. Or press any other button to exit from the PROGRAMMING mode after the INDICATOR
bIinks rapidly eight times, and the operation is not active.
To check the current code number
Press and hold the TV, VCR/DVD, SAT/CAB or AUX button for over 2 seconds until the lNDlCATOR turns
off. ReIease the button (the INDlCATOR wiII Iight again) and the remote controller enters the PROGRAM-
MlNG mode.
Press the 100 + button.
You may read the code number according to the INDICATOR display status as foIlows.
Code Number
First-digit
Second-digit
0 0
1 0
1 5
0 4
Notes: If there is no operation within 20 seconds during the steps mentioned above, the remote controIler
will automaticalIy exit from the appropriate operation.
If only your TV does not respond to the remote control, try 000 for your TV. If the batteries are weak
or exhausted, the remote control can' t function,either.
(2 sec.time interval between every two digits.)
First-digit
Third-digit
Blinks rapidly once
0
Blinks once
6
Blinks once
0
Blinks rapidly once
3
INDICATOR Display Status
Second-digit
Blinks rapidly once
Blinks rapidly once
Blinks five times
Blinks four times
22
PF Series Instruction Manual
Third-digit
Blinks rapidly once
Blinks six times
Blinks rapidly once
Blinks three times