VIBIA Wind Assembly Instructions page 2

1
Shade's screws
2
Allen key
3
Lamp structure
4
Shade
4055.
Net Weight 27,8 Kg
Caution
Before assembling and installing this product, carefully read the following:
-Switch of the mains before installing the lamp.
-Always use the recommended bulb
-If you wish to fix the lamp to the ground, choose the most adequate plugs and screws depending on the surface.
-Before the installation, make sure the installation surface will not be damaged. If this happens, it will be the installator´s responsibility.
-If the steel cable or the power cord of this lamp is damaged, it must be replaced only by the manufacturer or their technical service or by a person capacitated to this effect to avoid
any risk.
Wind
Design by Jordi Vilardell
ASSEMBLY INSTRUCTIONS
SUPPLIED MATERIAL
TECHNICAL SPECIFICATIONS
1 x T-5 Circline 2GX13 40W
1. 2.
4055
4 un.
2 un.
1 un.
1 un.
Class I. Product with an additional protection cable (grounds).
Dust-tight product. Protected against water spray.
Product that CAN be in contact with normally-flammable materials
(wood or others).
3. 4.