Factory Default Settings - NETGEAR GS305EP User Manual

Gigabit Ethernet Smart Managed Plus Switches Series 3XXEP and 3XXEPP

Factory default settings

You can return the switch to its factory settings. Use the end of a paper clip or some
other similar object to press and hold the Reset button on the front panel of the switch
for at least ten seconds. The switch resets and returns to the factory settings that are
shown in the following table.
Table 7. Factory default settings
Feature
Switch password
IP address
Subnet mask
DHCP mode
IGMP snooping
LAGs
VLANs
802.1p/DSCP-based QoS
Port-based QoS
Rate limiting
Broadcast filtering
Loop detection
Port speed
Flow control
Port mirroring
Factory Default Settings and
Technical Specifications
Setting
password
192.168.0.239 (if the switch is not connected to a network with a DHCP server)
255.255.255.0
Enabled
Enabled
None configured
Disabled. If enabled, by default, all ports are members of VLAN 1.
Enabled
Disabled
Disabled
Disabled
Disabled
Autonegotiation
Disabled
Disabled
90 User Manual