NETGEAR GS308P Installation

NETGEAR GS308P Installation

8-port gigabit switch with 4-port poe
Hide thumbs Also See for GS308P:

Advertisement

Installation

8-Port Gigabit Switch with 4-Port PoE
GS308P
Step 1. Connect the equipment.
IP Phone
Server
GS308P
Optional router
Step 2. Connect to power.
Internet
Optional modem
Step 3. Check the status.
Power LED
Right PoE LEDs (Ports 1–4)
Left Port LEDs (Ports 1–8)
On
PoE in use
Off
PoE fault
No PoE use (off)
PoE Max LED
Less than 7W of PoE power is available.
PoE Max. LED was activated in the previous two minutes
(blinking.
PoE ports are working normally (off).
1000 Mbps
link
10/100 Mbps
link
Activity
(blinking)
No link (off)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GS308P and is the answer not in the manual?

Questions and answers

Summary of Contents for NETGEAR GS308P

  • Page 1 Installation 8-Port Gigabit Switch with 4-Port PoE Step 2. Connect to power. Step 3. Check the status. GS308P Power LED Right PoE LEDs (Ports 1–4) Left Port LEDs (Ports 1–8) PoE in use 1000 Mbps link Step 1. Connect the equipment.
  • Page 2: Specifications

    See the regulatory compliance document before connecting the power supply. noncondensing NETGEAR, Inc. © NETGEAR, Inc., NETGEAR and the NETGEAR Logo are trademarks of NETGEAR, Inc. Any non‑NETGEAR December 2015 trademarks are used for reference purposes only. 350 East Plumeria Drive...

Table of Contents