Installation - Trust SMART Home START-LINE RECEIVER AWMR-300 Important Information Manual

INSTALLATION

Wire colors may vary per country.
Contact an electrician when in doubt about wiring.
This product is not suitable if the existing light switch
is interconnected to other light switches for multiway
switching. In case of a power cut, the assigned codes
will be retained.
MAXIMUM LOAD
Never connect lights or equipment that exceed the
maximum load of the receiver, as it can result in
defects, a short circuit or fire. If the internal fuse of
this receiver is overloaded, the warranty is void.
SHOCK HAZARD
Exercise caution when installing a receiver. Voltage
may be present, even when a receiver is switched off.
LIFE-SUPPORT
Never use Trust SmartHome products for life-support
systems or other applications in which equipment
malfunctions can have life-threatening consequences.
POWER CUT
When there is a power cut, the code of the
Trust SmartHome transmitter will still be stored in
the memory of the receiver. As soon as power is
restored, the receiver will switch off automatically.
Use your Trust SmartHome transmitter to switch
the light or electrical device back on again.
LEGAL INFORMATION
CE: Trust declares this device complies with the Directives as listed in Section 2 of this document.
WEEE: Dispose of the device at a recycling centre. More information: www.trustsmarthome.com
Warranty information: www.trustsmarthome.com/warranty
AWMR-300 MINI BUILD-IN SWITCH
INTERFERENCE
All wireless devices may be subject to interference,
which could affect performance.
The minimum distance between 2 receivers
should be at least 50 cm.
REPAIRING
Do not attempt to repair this product. There are no
user-serviceable parts inside.
WATER-RESISTANCE
This product is not water-resistant. Keep it dry.
Moisture will corrode the inner electronics and can
result in a short circuit, defects and shock hazard.
CLEANING
Use a dry cloth to clean this product. Do not use harsh
chemicals, cleaning solvents, or strong detergents.
HANDLING
Do not drop, knock, or shake the device.
Rough handling can break internal circuit boards and
fine mechanics.
ENVIRONMENT
Do not expose the product to excessive heat or cold,
as it can damage or shorten the life of electronic
circuit boards.
EN
2