How To Use - URBANGLIDE RIDE 80XL Translation Of The Original Notice

How to use

1. Choose a suitable place to ride.
2. Open the scooter as previously indicated.
3. Adjust the height of the handlebar according to your height.
4. Press the switch to turn on the scooter.
5. Put one foot on the scooter and leave the other foot on the ground.
6. Gently press the accelerator, place the foot on the floor, on the scooter. Press harder on the
accelerator to increase the speede.
7. To brake, simply press the front brake on the left side of the handlebar. Press harder on the brake to
slow down faster.
Warning ! The rear brake is not to use if you ride at full speed, it may damage the wheel.
Load the product
1. Make sure the charging connector is clean and dry.
2. Start by plugging the switch into the power interface, and then plug the other end of the charger into
the Segway.
3. When the red indicator lights up on the charger, it means charging is successful, if not, check that the
line is connected properly.
4. When the LED on the charger changes from red to green, the battery is fully charged. Stop loading.
Charge time too long could affect the life of the battery.
7