• Important: Do not try to lift the machine using SAFETY the carrying handle for Module 2 (heating module). Read the instruction manual carefully and ensure you understand the content - Do not allow children under the age of 3 near before using the product.
RISK ASSESSMENT Using spare parts or accessories that have not been recommended by El-Björn increases the risk of injury or damage to the machine. The machine is only intended for temporary drying and heating of rooms. When using electrical machinery, basic safety regulations shall always be followed, in order to reduce the risk of fire, electric shocks, burns or other personal injury.
Page 4
Air distributor. The air is drawn in through two filters (one filter TF 9EL) from the front and rear of the machine (Module 1). This acts like an intake noise attenuator as air pressure builds up in the fan compartment.
DESCRIPTION OF DISPLAY DESCRIPTION OF BUTTONS Scroll up/down Choose/Cancel 1. On/Off 2. Back 3. Press for 3 sec- onds to - Log out - Pause for 30 min - Switch off MENU DESCRIPTION Signal strength Current temperature Log-in authority level A = Administrator S = Service Relative humidity...
Page 6
STARTING/STOPPING THE DRYING FAN IN DRYING MODE To turn on the display, press the RED ON BUTTON on the control panel for 1 second. The above menu will appear in the display. The drying fan is pre-set by default to drying mode. To start the drying fan, press and hold the GREEN BUTTON for 2 seconds (the fan will start).
Page 7
CHANGING DEFAULT SETTINGS DESIRED TEMPERATURE, FAN SPEED, POWER (ELECTRIC DRYING FAN) To log in, press and hold any button for 1 second, the window below will appear. Use the arrows to enter your password, and press the GREEN button to confirm. There are two levels of authorisation: Administrator and Service.
LIST OF ALARMS Time to replace filter: • To cancel the alarm, press the green button • The alarm symbol will shrink, but will stay on until the filter is replaced The product has overheated for some reason The product has not been switched off correctly: •...
TECHNICAL DATA TF 9EL TF 18EL TF 36EL 400 TF 72EL 400 400 VAC 400 VAC H incl. air distributor 2150mm 2150 mm 2200 mm H excl. air distributor 1000mm 1200 mm 1400 mm 440mm 560mm 740 mm 740 mm...
That the filter is fitted and is clean and undam- aged. TF 9EL EBC: Position the machine in its desig- That cables and connectors are undamaged and in nated place. Connect the El-Björn metal air distrib- good condition.
OPERATION HANDLING DURING NORMAL OPERA- HANDLING DURING ABNORMAL OPER- TION ATION Start & stop Check that the fuses in the nearest electrical cabinet See the display instructions. have not blown and that the residual current device Adjusting the indoor temperature has not tripped See the display instructions.
Cleaning The machine emits too little air • Always replace the filter after use. • Check that the air distributor/vents are not • Clean externally with a mild soap solution and blocked. a damp cloth. The display can be cleaned with •...
Need help?
Do you have a question about the TF 9EL and is the answer not in the manual?
Questions and answers