By Pass Linkage; Fuses - Dixon ZTR RAM 44 Operator's Manual

6. By pass linkage

When pushing or pulling the mower, be sure
to engage the IZT (Integrated Zeroturn
Transaxle) bypass linkages. The IZT bypass
linkages are located on the rear of the frame,
below the rear engine guard.
• Raise the deck into the highest cutting
position.
• Pull the IZT bypass linkages out and into
the slots and release so that it is held in
the bypass position.
• To reengage the IZT's to drive, reverse
the above procedure.

7. Fuses

The fuses are located in a holder at the right
hand side of the battery compartment. They
are flat pin fuses of the same type used in
automobiles.
There are two fuses.
Fuse ratings and functions:
• 20 A, Primary fuse.
• 7.5 A, Mower deck coupling.
20
English-
CONTROLS
1. IZT Bypass linkage
Bypass linkages
1. Head outside of rear deck
2. IZT Bypass linkage in bypass position
Bypass position

Fuses

CZ10-2
1
2
CZ12
8011-483