Advertisement
Join main formers and place rib doublers , check the drawing for the correct position of the doublers
and or retract formers.
Mark the main-formers ribs on the bottom sheeting, place main-formers on sheeting place ribs , do
not glue yet , make sure for straightness .
if all seems ok then pin down the main former and start glueing the ribs with thin ca one by one to the
bottom sheeting, note roll the ribs over the sheeting and apply ca
Glue wing assembly to bottom sheeting.place scrap fills, aileron leading edges
Place sub leading edge to the bottom sheeting and to the ribs.
Do this the same for the other side of the wing., sand the sub leading edge to the ribs .
Advertisement
