Roper Rhodes Diverge Floor Mounted Unit Installation

Diverge Floor Mounted Unit
Installation & aftercare instructions (600mm Unit Shown for Illustration Purposes)
Please retain for future reference
Installation Procedure:
Securing the unit
It is recommended that the unit and basin are secured to a suitably reinforced wall to ensure stability. The units can be secured through the holes in
the back upper brace. The wall plugs supplied are only suitable for solid stone/brick walls. For plasterboard walls use specialist wall plugs along with
supplementary wall strengthening as units can be very heavy. Seek advice from a specialist about the suitability of fixings to be used.
Wear suitable eye protection when drilling. Take care when using power tools near water - the use of a residual current device (RCD) is
recommended. Beware of hidden pipes or cables. Take care when drilling tiled surfaces as the drill might slip. Use a piece of masking tape to prevent
the drill from wandering.
Door Hinge Adjustment
Hinges may require adjustment for correct door alignment. This is achieved with the adjustable soft close hinges using the
adjustment screws A, B and D (see Drawing 1). To access these you will first have to remove the screw cap cover. The hinges also
feature a quick release mechanism to quickly and easily detach the door from the furniture frame, this is activated by pressing
button C (see Drawing 1).
Drawing 1
1.
Door
Furniture frame
Drawer Fascia Adjustment
Fascias may require adjustment for correct alignment. If adjustment is required follow instructions below.
3
Rotate plastic cover.
To make adjustment 1 (Up and Down) turn screw A (see drawing 4)
To make adjustment 2 (Left and Right) turn screw B (see drawing 4)
600, 800 & 1000mm
D
A B C
D
4
B
Customer Services, Roper Rhodes Ltd, Brassmill Lane Trading
Estate, Bath, BA1 3JF
Tel:01225 303 900 | Fax: 01225 448 877
Email: sales@roperrhodes.co.uk | Web: www.roperrhodes.co.uk
Drawing 2
2.
To make adjustment 1 (see Drawing 1)
tighten/loosen adjustment screw A.
To make adjustment 2 (see Drawing 1)
simply turn screw B
To make adjustment 3 (see Drawing 1)
unscrew screws D. Move doors into
correct position and re-fix
Button C is the quick release, press this
on both hinges to remove a door by
releasing the hinges from their
mounting plates.
2
A
3
3
1
2
1
RR-DIVFM REV : 21.07.2014