Pairing With A Radio Wireless Commander/Receiver (For Radio Wireless Flash Photography) - Sony HVL-F28RM Help Manual

Help Guide
Flash
HVL-F28RM

Pairing with a radio wireless commander/receiver (for radio wireless flash photography)

To perform radio wireless flash photography with this flash unit, you need another flash unit that supports radio wireless
communications or a radio wireless commander/receiver (not supplied) in addition to this flash unit and must pair them both
together.
For details, refer to the operating instructions supplied with your device.
Hint
You need to bring both devices within 1 m from each other for pairing.
Turn on the power to this flash unit and the other device, and then configure one flash unit as the commander unit
1
and the other as the receiver unit.
To configure this flash unit as the commander unit, turn its power switch to "ON."
To configure this flash unit as the receiver unit, turn its power switch to "A," "B," or "C."
Press and hold the PAIRING buttons on this flash unit and the other device for 3 seconds.
2
The LINK lamps on the commander and receiver units flash in green.
On the commander unit, the CMD lamp lights.
When pairing is established, the LINK lamp on the receiver unit turns flashing to lit.
On the commander unit, the LINK lamp stays flashing and the unit remains in the pairing standby state.
To pair with a second or subsequent receiver unit, repeat step 2 with the device that you use as the receiver unit.
To bring the commander unit out of the pairing standby state, press the PAIRING button.
16