Wireless-Flash Mode (Wl) - Sony HVL-F32M Operating Instructions Manual

Wireless-flash mode (WL)

In the wireless-flash mode, you can separate the flash unit from the
camera and use it
[A] Using the HVL-F32M that is separated from the camera (off-
camera flash) (page 33)
[B] Using the HVL-F32M that is attached to the camera as the
controller (page 35)
Wireless Flash Range
The wireless flash requires 2 flash units (includes the built-in flash of the
camera). When the attached or built-in flash fires, it triggers the
operation of the off-camera flash unit. Follow the points below when
positioning the camera, flash, and subject.
• Place the off-camera flash within the circle in the following diagram.
• In the wireless-flash mode, you cannot use a flash meter or color
meter in wireless-flash mode because the pre-flash fires.
• In the wireless-flash mode, the flash coverage for this flash unit is
automatically set to 24 mm.
• The built-in flash of the A-mount camera, or the HVL-F20M, HVL-
F32M, HVL-F43M or HVL-F60M can be used as the controller.
1 - 5 m
(see Table 1)
Do not place the flash
directly behind the
subject
Place the camera and flash unit within
a 1 m to 5 m radius of the subject
1 - 5 m
(see Table 2)
29
GB