Download Print this page

Orliman LUMBITRON ELITE LTG-285 Instructions For Use Manual page 2

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 2
REF.: LTG-285 | LTG-275 | LUMBITRON® ELITE
English
INSTRUCTIONS FOR USE AND PRESERVATION
Dear customer,
Thank you for your trust in this Orliman product. You have acquired a quality product with a high
medicinal value. Please, read the instructions carefully. If you have any doubt, get in contact with
your doctor, your orthopaedist specialist or our customer service department. Orliman appreci-
ates your choice and wishes you a speedy recovery.
REGULATION
These products satisfy the European Medical Device Directive 93/42/CEE (RD. 1591/2009). A Risk
Analysis has been carried out (UNE EN ISO 14971) minimising all the existing risks. The trials have
been carried out in accordance with the European regulation UNE-EN ISO 22523 of Prosthesis and
Orthesis.
SUITABLE FOR
Depending on the product:
A-Lumbosacral Back Support:
Lumbago, lumbosciatica, degenerative processes, weak and atonic muscles, disc hernia, pre and
post-surgical treatment.
B-Dorsolumbar Back Support:
Dorsalgias, degenerative processes, kyphosis, osteoporosis, crushed vertebrae, pre and post-
surgical treatment.
*In the case of prominent abdomens the pendulum abdomen support is recommended.
FITTING INSTRUCTIONS
THE PRODUCT SHOULD BE ADJUSTED BY YOUR ORTHOPAEDIC TECHNICIAN OR IN ACCORDANCE
WITH DOCTOR'S ORDERS.
In order to obtain a greater degree of therapeutic effectiveness in the different pathologies and to
prolong the life and utility of the product, it is fundamental that the correct size adequate for each
patient or user is chosen (enclosed in the packet is a diagram with all the sizes and the equivalent
in centimetres). An excess compression can produce intolerance, therefore we recommend that
the compression be regulated to an optimum degree.
To fit observe the following aspects:
Lumbitron
:
®
A-Lumbosacral Back Support:
Place the orthesis around the body so that the bones are placed in the centre of the back and 3 cm
above the gluteal fold, then proceed with the tightening and closure.
Velcros: Adjust the velcro closing systems to achieve the desired compression.
Crossed straps: Tighten the posterior crossed straps by means of the front velcro fastener.
B-Dorsolumbar Back Support:
For dorso lumbar support, carry out the procedure as described above, then tighten the shoulder
pins at the back towards the front, passing them under the armpit, subsequently crossing them
and carrying the ends to the abdominal wall, sticking them among each other, until the necessary
traction is obtained in order to achieve a tolerable retropulsion of the shoulders for the patient.
Both fasteners should be placed above the pubis lifting the abdominal wall.
*Includes a removable lumbar foam cushion (heat effect) and better adaptation of lordosis (in
some cases the lumbar cushion is not included).
Lumbitron
Elite/Lumbitron
Elite Duo:
®
®
Belt placement:
⋅ Wrap the brace around the body so the stays are in the centre at the back.
⋅ Insert your fingers in the corresponding clips on the right and left parts of the fasteners.
⋅ Press the stomach on the left side of the fastener and pull from the right until the hook can be
fastened.
Belt placement:
⋅ Insert the rear centre plate by centring on the stays at the back of the belt.
⋅ After fastening with the hooks, insert your fingers at each end of the elastic straps.
⋅ Pull as much as necessary and secure on velour in the abdominal area with the hook fastener.
› For proper use of the orthosis it is advisable not to modify its height position once the Velcro straps are adjusted, since the fabric could tear. If you need to
adjust the height of the orthosis, first loosen the Velcro straps, re-position the orthosis at the desired height, and adjust the tension of the Velcro straps.
PRECAUTIONS
The constructive material is inflammable.
Do not expose these products to situations where they could ignite. If this were the case remove
them quickly and use the necessary measures to put it out. The material used is hypoallergenic,
however we cannot guarantee 100% that in some determined cases it will not produce allergies, if
this occurs, remove the product and see the doctor that prescribed it.
In case of minor irritations due to sweat, we recommend the use of a cotton sock, to separate
the skin from contact with the material. For small inconvenience caused by sweat, we recommend
using an interface to separate the skin from contact with the tissue. If rash, irritation or swell-
ing to remove the product and consult a doctor or prosthetist. Contraindicated in open scars with
swelling, redness and accumulation heat. The product contains natural rubber latex and may elicit
allergic responses in individuals who are sensitised to latex.
RECOMMENDATION-WARNINGS
These products are to be used only by those which have been medically prescribed to do so. Per-
sons unconnected to such prescriptions should not use them. When the product is not being used,
store in its original packaging. In order to dispose of the packaging and the product, strictly com-
ply with the legal norms of your community.
The use of the orthesis is conditioned to the recommendations of the prescribing doctor, therefore
it must not be used for any other means than those prescribed.
For the validity of the guarantee, the issuing establishment should comply with this sheet of in-
structions.
MANUFACTURE-CHARACTERISTICS
The material features used in production have been tested and approved and meet all the Euro-
pean quality requirements.
All the products are produced with high quality materials and offer an unbeatable comfort and
quality of use. All products offer restraint, stability and compression for the optimum treatment of
the pathologies for which they have been designed.
RECOMMENDATIONS FOR PRESERVATION AND CLEANING
Stick the velcros to each other (if the orthesis has any), wash periodically by hand with a damp
cloth and a neutral soap. To dry the orthesis, use a dry towel to absorb most of the dampness and
leave to dry at room temperature. Do not hang up or iron and do not expose to direct heat sources
such as stoves, heaters, radiators, direct sun light etc. During use or during washing do not use al-
cohols, ointments or dissolvent liquids. If the orthesis is not properly dried any detergent residues
could irritate the skin and deteriorate the product.
GUARANTEES
ORLIMAN, S.L.U. Guarantees all its products, as long as these have not been manipulated or al-
tered from their original state. Does not guarantee those products in which as a result of misuse,
deficiencies or breakage of any kind, its original state has been altered. If you observe any defi-
ciency or anomaly, communicate this immediately to the establishment from which it was obtained
in order for it to be changed.
ORLIMAN, S.L.U. Appreciates your choice and wishes you a speedy recovery.

Advertisement

loading

This manual is also suitable for:

Lumbitron elite ltg-275