S&P TL-40 Manual page 8

given supervision or instruction concerning use of the appliance in a safe way and understand
the hazards involved.
• Children should not play with the product.
• Before carrying out any maintenance work, or during long periods without use, make sure that
the device has been disconnected from the mains.
• Do not clean the product while it is working and do not immerse it in water.
• Do not handle the heater with wet hands.
• Do not coil the power cable around or on top of the product while it is working.
• If the cable gets damaged it must be replaced by S&P – take the equipment to our offi cial S&P
dealer because the work must be done by specialist personnel to avoid any risk of damage.
• The air outlet grille should be located at the top.
• Only for internal use.
2. THE PRODUCT
Description of the product (Figure 1):
1 Outlet air
2 LED by overheating
3 Transport handle
4 Inlet air
5 Inlet air fi lter
6 Extension to increase stability
7 Thermostat
8 Power selector
3. USE AND OPERATION
• Select the power with power selector
O Stop
Fan (cold air)
Hot air heater (1000W)
I
II Very hot air heater (1800W)
• Turn the thermostat control until it is at the maximum position.
Min.
• Once the room has reached the desired temperature, slowly move the control until there is a soft "click" and the device is
disconnected. From this time the heater turns on and off automatically, keeping the pre-selected comfort temperature.
• Anti frost device thermostat
This device is especially useful in places where low temperatures are reached and there is a risk of water freezing in
internal water pipes. The heater will automatically maintain the temperature of the room at about +5ºC when left on this
setting.
• IMPORTANT: The LED will illuminate only if the heater stops for overheating, whether due to a malfunction of the same
or that the heating is being used inappropriately.
8
Max.