S&P TLS-601 Instructions For Use Manual page 12

SWITCHING ON AND OPERATION (Fig.1)
Once you have checked that the mains voltage coincides with the voltage indicated on the name plate,
connect the convector.
1.- The Led (f) inform to the user that the convector is connected to the power supply.
2.- Select the power using the power selector command and turn the thermostat command in the direction
of clockwise to its maximum position :
3.- Once the room has reached the desired temperature, turn the thermostat control anticlockwise until you
hear a slight click. When the thermostat control is in this position, the convector will connect and disconnect
automatically to keep the pre-selected temperature constant.
SUPPORT HEATER (Only TLS-603T)
To accelerate the heating room, it can also connect the support heater (Turbo).
ANTI-FREEZE PROTECTION
The convectors incorporate an anti-freeze device which triggers then convector when the room temperature
drops below +5ºC.
To activate this device just connect the convector to the mains, place the power selector in any of the active
positions and the thermostat control in the position
The convector will remain disconnected until the room temperature drops below +5ºC when it will start
automatically to ensure the temperature is maintained over +5ºC.
This device is particularly useful in places where low temperatures are common and the water pipes are
likely to freeze.
POWER SELECTOR
0
1.000 W
2.000 W
2.000 W + Support heater *
* Option only for the model TLS-603T
12
12
OFF