Holeless Telescopic Jack Installation - ITI HOLELESS Installation Manual

Hardware
For the cylinder installation

1 x Air bleeder (1/8" NPT)

1 x Straight coupling for oil return (1/8" NPT)

1 x 90° coupling for oil return (1/8" NPT)

1 x Clear tubing ∅3/8", 8' longer than the closed length

1 x Roll of Teflon tape
Tools

Buffers

Bolts
Holeless telescopic cylinder alignment
1. Temporarily locate the jack's support plate on the pit floor through the centerline of the mounting plate,
under the car.
2. Position the jack on the pit support plate, plumb the jack with a level and fix a clamp on the wall of the
jack close to the head.
3. Set the plumb line off the rails in the hoist way through the centerline of the platen plate under the car, at
the highest possible point.
4. Adjust the wall clamp, so the jack will be centered on the plumb line.
5. Plug the hydraulic feed line to the jack. When installing the telescopic jack, the oil sypply line should be
connected as quickly as possible to reduce the loss of pre-filled oil.
6. Raise the jack to approximately half the travel and, using plumb line, check that the jack stays on the
same centerline as the mounting plate, under the car.
Holeless telescopic jack
7
Installation guide
installation