ITI HOLELESS Installation Manual page 14

SOLUTIONS
in motions
10. Install the new check valve and tighten it well.
11. Verify is the seals have not been damaged and replace them it it's necessary.
12. Insert the sections back in the cylinder and make sure that they are well centered. Screw back the head
taken off previously as soon as possible for better alignment. There is no need to screw it very tight at this
moment.
13. Just before the jack reaches a completely retracted position, unscrew the same head again to fill the jack
with the recuperated oil. Then, screw the head firmly. Another option is simply to put the oil back in the
power unit. Do not forget in this case to have the heads firmly screwed. Moreover, a pressure will have to
be maintained on the piston to allow the oil to fill the jack.
14. Re-install the bleeder taken off previously.
15. Attach the piston to the car.
16. Follow the procedure described further to resynchronize the jack.
14
Holeless telescopic jack