Maintenance Chart - ADENDORFF MAC-AFRIC COMPRE-024 Original Operating Instructions

AIR COMPRESSORS
DIRECT & BELT DRIVEN MANUALS
contact the Adendorff Service Department.
MAINTENANCE TIPS FOR AIR COMPRESSORS
• DRAIN THE MOISTURE FROM THE TANK DAILY!
• CHECK AND CHANGE THE COMPRESSOR OIL – If you're running a compressor that uses oil, you should be checking
it on a daily basis to make sure that your machine is topped up. You should change you oil every 300-500 hours to
ensure maximum functioning of your air compressor.
• CHECK AND CHANGE AIR FILTERS - Having a dirty air filter will force the compressor to work harder due to a heavy
build-up of dust and dirt which will cause internal damage. You should check you air filter daily and change if
necessary. It is advisable that you change the air filter(s) after every six months and clean weekly.
• DO NOT USE EXTENSION POWER CORDS – this will in turn cause a voltage drop thus causing the electrical motor
to labour and the windings on the motor will burn out.
IMPORTANT TIP – rather plug the compressor at the wall plug on a separate circuit and use longer air-line hose
– applicable for single phase 230 V units. Three phase installations should be installed by a qualified electrician
directly at the power supply source.

MAINTENANCE CHART

CHECK LIST
Oil level
Air Receiver
Intake Filter
Oil breather
Fan and cooling fins
Inlet and outlet valves
Non Return Valve
Belt Tension
Big end bearings
Main bearings
Piston Rings
Cylinder head bolts
DAILY WEEKLY
Check
Drain
Check/Clean
Check/Clean
Clean
Clean
Check
Check torque settings
COPYRIGHT ADENDORFF MACHINERY MART
6 MONTHLY NOTES
Change
Replace if necessary
If worn contact
Adendorff Machinery
Replace if worn
Check adjust/ Replace Does not apply to
if worn direct drive
If worn Contact
Check
Adendorff Machinery
If worn Contact
Check
Adendorff Machinery
If worn Contact
Adendorff Machinery
If worn Contact
Adendorff Machinery
9