Panasonic 2WAY MULTI U-16GE3E5 Test Run Manual page 30

 Checking the initial values
Check the initial values of the outdoor unit
 Press the HOME (SW004) key for longer than 1 second, and the menu item number will be displayed. "   "
(If the STOP SW (SW001) is on total stop, then after displaying "    ", "      " will be displayed)
 Next, press the UP (SW005) or DOWN (SW006) key to display menu item number "    ".
 After displaying "    ", "      " is displayed. While "      " is displayed press the SET (SW007)
key. This displays the system address setting. (Example : "  ")
 In this condition use the UP (SW005) or DOWN (SW006) key to select the system address setting, outdoor unit
address setting, number of outdoor units connected setting, number of indoor units connected setting, type set-
ting, gas type setting and automatic address startup, etc.
Display






↑DOWN



↓UP








System address setting
Outdoor unit address setting
(Only change this when connecting multiple W MULTI outdoor units.)
Number of outdoor units connected setting
(Only change this when connecting multiple W MULTI outdoor units.)
Number of indoor units connected setting
Capacity setting (cannot be set)
Gas type setting
Refrigerant setting (do not change)
Generator setting (No generator available)
Model 1 setting
Model 2 setting
Destination setting
Hot water temperature setting
Oil replacement time indication setting
Single phase setting
Tube connection check (Use for W Multi)
Heating automatic address setting
Cooling automatic address setting
II - 15
Function