AMX AXD-CP4/A Specifications page 3

cp4/a touch panel
LIGHT DETECTOR:
• Photosensitive light detector for adjustment
of the panel brightness.
MOTION SENSOR (PIR):
• Proximity Infrared Detector to wake the
panel when the panel is approached.
• Activation range: + 20° vertically from center
and + 45° horizontally from center.
IR RECEIVER:
• 38 KHz, one-way IR reception (of AMX codes
only)
MICROPHONE:
• Used for audio conferencing applications
(intercom functionality)
SPEAKERS:
• Frequency response 450 Hz - 7 KHz
AXLINK/PWR:
• 4-pin 3.5 mm mini-Phoenix connector for
communication to the AMX Central
Controller providing both data and power
AUDIO:
• 8-pin 3.5 mm mini-Phoenix connector for
audio input/output
PROGRAMMING PORT:
• 2.5 mm stereo female conductor jack (side
mounted)
ARGENTINA • AUSTRALIA • BELGIUM • BRAZIL • CANADA • CHINA • ENGLAND • FRANCE • GERMANY • GREECE • HONG KONG • INDIA • INDONESIA • ITALY • JAPAN
LEBANON • MALAYSIA • MEXICO • NETHERLANDS • NEW ZEALAND • PHILIPPINES • PORTUGAL • RUSSIA • SINGAPORE • SPAIN • SWITZERLAND • THAILAND • TURKEY • USA
ATLANTA • BOSTON • CHICAGO • CLEVELAND • DALLAS • DENVER • INDIANAPOLIS • LOS ANGELES • MINNEAPOLIS • PHILADELPHIA • PHOENIX • PORTLAND • SPOKANE • TAMPA
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • 469.624.8000 • +1.469.624.7400 • 469.624.7153 fax • www.amx.com
INSTALLATION KIT (AXD):
• 6 included blank buttons (pre-mounted into
the AXD chasis)
• One bag containg 12 custom buttons (2
embossed/10 pre-printed)
• One 4-pin 3.5 mm mini-Phoenix data/power
connector (41-5047)
• One 8-pin 3.5 mm mini-Phoenix audio con-
nector (41-5083)
• Drywall clip set 2 -drywall clamps and 2- #8
(2" long) screws (62-5924-05)
• Quick Start Guide (93-5921-01)
• One 2.5 mm stereo conductor programming
cable (FG10-817)
INSTALLATION KIT (AXT):
• 6 included blank buttons (pre-mounted into
the AXT chasis)
• One bag containg 12 custom buttons (2
embossed/10 engraved)
• One 10' tabletop cable (CA-5921-01)
• Quick Start Guide (93-5921-01)
• One 2.5 mm stereo conductor programming
cable (FG10-817)
OPTIONAL ACCESSORIES:
• PSN6.5 Power Supply (12 VDC) (FG423-41)
(recommended for use on the CP4/A)
• CB-CP4/A (FG033-10) Conduit/wallbox
(includes drywall clips and screws for installa-
tion to studs during the construction phase)
• Conduit/Wallbox should only be mounted to
a beam before a drywall is installed (pre-wall)
• Axcess programming cable (DB9 to DB9),
(FG10-727)
6.240
6.240
AXT-CP4/A (Front View)
AXT-CP4/A (Rear View)
4.215
4.215
AXT-CP4/A (Side View)
4.992
AXT-CP4/A (Top View)
4.992