Takara Belmont RS Adria II Operating Manual page 21

4
Close the hot water and water stop valves.
To prevent water leakage, always check
that the stop valves are completely closed
Caution
before cleaning or draining the water from
the strainer.
5
Clean the strainer.
When the strainer is detached, the water in the pipe will come
out. Therefore, rotate and detach the strainers of the check
valves for hot water and water, while catching the water in a
container. After completely draining the water from the check
valve, clean the strainer by removing dust and dirt, set it in
the original position, and tighten firmly.
(Tool required: a blade-head screwdriver)
Caution
6
After checking that the strainers have been fastened properly,
open the stop valves.
Check that there are no water leaks from the check valve.
7
Mount the maintenance cover onto the main unit.
The maintenance cover can be mounted by hooking the
three latches on the main unit. First, hook the top latch and
then hook the bottom two latches.
Check that the maintenance cover is properly
secured with the three latches. If not, water
Caution
may penetrate the main unit resulting in
system failure.
The "Parts Replaced on a Regular Basis" described on page 26 must be replaced on a regular basis
to ensure and maintain safety and performance. Any part that is outside the designated replacement
period must be replaced even if there is no problem during use. Our company will not assume
Note
responsibility for any harm, damage, or defects attributed to the fact that a part was not replaced
within the designated period.
Removing the strainer from the hot water
supply pipe may cause hot water to spill out.
Take extra care when draining the hot water.
The drain nut and strainer should be
tightened firmly. If they are not, there is a
possibility of water leaks.
If the drain water spills onto the floor,
immediately wipe it up.
Detach
Strainer
Latch
Latch
21
Check Valve
Loosen
Attach
Tighten
Open
Close
Stop Cock
Latch