Maintenance - Takara Belmont RS Adria II Operating Manual

Never use volatile chemicals such as thinners, alcohol, gasoline or kerosene, cleaning products
such as abrasire wax , a sponge with a scourer, detergents that include organic solvents,
Caution
acidic, alkaline or chlorine-based detergents, or scouring pads. Failure to follow this instruction
may cause scratches or discoloration.
Be sure to execute daily maintenance according to the maintenance procedures stated in this
section. In the case of insufficient or improper maintenance or when periodically replaced parts
Caution
are not replaced, the customer shall be responsible for any harm, damage, or defects that result,
and our company shall not assume responsibility.
Hair catcher
Pull out the hair catcher located under the drain cap and remove any hair
that has been caught. The hair catcher is a consumable supply. Replace
the hair catcher if it is extremely dirty or the surface has deteriorated.
(available at additional cost)
Clean the hair catcher as regularly as possible.
Continuing to use the hair catcher without cleaning can
cause the drain to become blocked with hair, leading to
Caution
water overflowing and unhygienic conditions. Try to
clean the hair catcher after each shampoo.
Trickle stopper rubber
At the end of work each day, wash with water to remove any hair or chemicals.Trickle stopper rubber is a consumable
supply. Replace the trickle stopper rubber if it does not fit the shower hose firmly, or if it has become slippery or the
surface has deteriorated. (available at additional cost)
The trickle guard rubber will not stop the water leaks completely. The water that overrides the
rubber may fall on the main unit or on the floor. If this is the case, immediately wipe the water off.
When the water is allowed to remain, there is a possibility of damage to the main unit or people
Caution
slipping and falling due to water on the floor. In some cases, water may result in damage from
water leaks.
<Replacement method>
1
Remove the shower head.
2
Remove the old trickle stopper rubber.
3
Spread open the new trickle stopper rubber with both hands and fit it
on to the hose.
• The most effective attachment position is approximately 10 cm from
the base of the shower head.
4
Attach the shower head.
• Replacement is easier if performed by two people. The rubber may
expand slightly during replacement, however it will contract and
secure itself after some time.

Maintenance

Thinner
Kerosene
Alcohol
16
Chemicals
Wax
Drain cap
Drain
Shower head
Trickle stopper rubber
Hair catcher