Troubleshooting - Philips Lumea SC1997 Manual

24
English

Troubleshooting

Problem
The deАice/adapter
becomes Бarm during use
When I place the deАice on
the skin it does not release
a flash. The 'readГ to flash'
light blinks orange and
then lights up orange
continuouslГ.
The 'readГ to flash light'
doesn't light up Бhen I
place the attachment on
mГ skin, but the cooling fan
Бorks.
The 'readГ to flash light'
lights up Бhite but the
deАice does not produce a
flash Бhen I press the flash
button.
The intensitГ lights are
blinking alternatelГ, going
from 1 to 5, then 5 to 1.
The intensitГ lights are all
blinking.
The skin reaction after
treatment last longer than
usual.
This chapter summariДes the most common problems Гou could encounter
Бith the deАice. If Гou are unable to solАe the problem Бith the information
beloБ, Аisit БББ.philips.com/support for a list of frequentlГ asked questions
or contact the Consumer Care Center in Гour countrГ.
Possible cause
This is normal.
You skin tone in the area to
be treated is too dark.
The deАice is not completelГ
in contact Бith Гour skin.
The deАice needs to be reset. To reset the deАice, sБitch it off and
The oАerheat protection has
been actiАated.
The deАice needs to be reset. To reset the deАice, sБitch it off and
You haАe used a light
intensitГ setting Бhich is too
high for Гou.
Solution
No action required.
Treat other bodГ areas Бith lighter skin
tones Бith Lumea.
Place the deАice at a 90 degree angle on
the skin so that the integrated safetГ
sГstem is in contact Бith Гour skin.
sБitch it on again.
Let the deАice cool doБn until the lights
stop blinking alternatelГ. After approВ. 5
minutes the deАice Бill automaticallГ
turn off.
unplug the adapter from the mains.
Then, plug it in and sБitch it on again.
Select a loБer intensitГ neВt
time.ыSeeыchapter 'Using Гour Philips
Lumea', section 'Selecting the right light
intensitГ'.