Garp Timer - AMX NXA-ENET24 Instruction Manual

Command Mode
Example
Console#show gvrp configuration ethernet 1/7
Eth 1/ 7:
Gvrp configuration: Disabled
Console#

garp timer

Use this command to set the values for the join, leave and leaveall timers. Use the no form to
restore the timers' default values.
Syntax
Default Setting
Command Mode
Command Usage
Set GVRP timers on all Layer 2 devices connected in the same network to the same
values. Otherwise, GVRP may not operate successfully.
NXA-ENET Software Management Guide
Normal Exec, Privileged Exec
garp timer {join | leave | leaveall} timer_value
no garp timer {join | leave | leaveall}
{join | leave | leaveall} - Which timer to set.
timer_value - Value of timer.
Ranges:
join: 20-1000 centiseconds
leave: 60-3000 centiseconds
leavall: 500-18000 centiseconds
join: 20 centiseconds
leave: 60 centiseconds
leaveall: 1000 centiseconds
Interface Configuration (Ethernet, Port Channel)
Group Address Registration Protocol is used by GVRP and GMRP to register or
deregister client attributes for client services within a bridged LAN. The default values
for the GARP timers are independent of the media access method or data rate. These
values should not be changed unless you are experiencing difficulties with GMRP or
GVRP registration/deregistration.
Timer values are applied to GVRP for all the ports on all VLANs.
Timer values must meet the following restrictions:
leave >= (2 x join)
leaveall > leave
Command Line Interface
353