Table of Contents
Advertisement
The anchor does not free fall.
Chain jumps / slips on the
chainwheel.
The clutch cones are not greased.
The clutch is not fully disengaged.
The band brake is not disengaged.
Disc springs (10) not fitted.
Pawl (28) engaged.
The chainwheel not selected
correctly.
Chain twisted between windlass and
bow roller.
Vertical angle of incoming chain
bigger than 2 degrees (see Picture
2.1).
22
Disassemble the cones (9), clean and
grease them as described in Section
2.4.
Disengage the clutch fully.
Disengage the band brake fully.
Fit disc springs as described in 2.4.
Disengage pawl.
Contact Maxwell with correct
identification of the chain used on
board.
Untwist the chain.
Check the installation. If the problem
persists, some height adjustments
might have to be made.
Hide quick links:
Advertisement
Table of Contents
