System Initialization; 2-Point-Initialization - Waterbird ITSC1000 User Manual

Multi Slider – User Manual

2.3 System Initialization

2-Point-Initialization

For 2-Point-Initialization the END Position needs to be initialized first. Therefore, use the
buttons "<<<" and ">>>" to move the slide to your intended END position and hit the blue
"END" button.
The label of the blue button changes from "END" to "HOME". So move the slide to your
intended HOME position. After hitting the blue "HOME" button the system is initialized.
1-Point-Initialization
If Initialization mode is set to 1-Piont-Initialization (cf. 2.8), then only the HOME position needs
to be initialized.
The END position is defined be the position area length stored on the Control Unit. Position
and length can be changed by performing a 2-Point-Initialization and saving the controller
settings afterwards. (cf. 2.8 – Controller Settings)
Copyright © 2017 Waterbird Systems GmbH
www.waterbird.at
After powering or resetting the Control Unit the system is not
initialized. That means the software does not know the position
of the slider.
Therefore the endpoints (HOME and END position) needs to be
initialized in order to gain full functionality.
Initialization can be performed by 2-Point (default) or 1-Point
initialization. (cf. 2.8 – Initialization Mode)
With the initialization of the Multi Slider, the possible movement
area of the slide is bordered by the endpoints. This position area
is used for all automated features like Timelapse and Ping-Pong.
Furthermore, once initialization succeeded, it is not possible to
move the slide outside those defined endpoints.
Initialization can be cleared by hitting the blue "RESET" button.
- 10 -