M
20w Marietta Floor Lamp
20M15BZD-SHPR
INS120044
REV110612
L
G
E
G
F
English
K
CONGRATULATIONS!
You've purchased the finest in natural lighting technology
with your new OttLite
®
STEP 1: PRODUCT REGISTRATION FORM
Please complete the enclosed Product Registration Form
and return it today by mail, or register online by going to:
www.ott-lite.com/warranty.
J
WARNING: To prevent electric shock, make sure the lamp
is not plugged in until all assembly steps are complete.
STEP 2: LAMP ASSEMBLY
Make sure the lamp is not plugged into an electrical
1.
socket.
2.
Unpack all lamp parts and lay out on the floor with the
base (A) lying flat.
3.
Thread middle pole (C) to upper pole (D) by hand,
D
turning clockwise until tight.
4.
Thread lower pole (B) to middle pole (C) by hand,
turning clockwise until tight.
5.
Thread lower pole (B) to base (A) by hand, turning
clockwise until tight.
6.
If installed, remove socket ring (F) from socket
assembly (G).
7.
Place shade (E) on socket assembly (G).
C
8.
Secure shade (E) in place by threading socket ring (F)
onto socket assembly (G) and firmly tighten by hand.
Install bulb following BULB INSERTION/
9.
REPLACEMENT instructions.
10.
Plug the lamp into a standard 120V outlet.
Adjust shade height and angle by turning thumb levers
11.
(J, K) counterclockwise to loosen, reposition shade (E)
then turn thumb levers (J, K) clockwise to tighten.
B
Turn lamp on or off by rotating the switch (L) located on the
socket clockwise.
STEP 3: BULB INSERTION/REPLACEMENT
Make sure the lamp is not plugged into an electrical
1.
socket.
2.
If the lamp has been in use, allow it to cool
A
approximately 5 minutes before proceeding.
9931
To install a bulb (M) in the socket, grasp the bulb
3.
firmly in your hand and push the bulb straight into the
socket by applying pressure to the base of bulb, until it
product.
"snaps" into place. Do not apply pressure to the glass
end of the bulb.
4.
To remove a bulb (M) already installed in the lamp,
grasp it firmly in your hand and pull it straight out
of the socket. Do not twist or turn the bulb while
removing it from the socket.
5.
Turn lamp on or off by rotating the switch (L), located
on the socket, clockwise.
Please note that in operation, OttLite
dimmable.
Enjoy your OttLite
This lighting system is designed for use with OttLite
Type
products voids the warranty and may result in damage
to the lighting system.
CAUTION!
cord of this luminaire is damaged, it shall be exclusively
replaced by the manufacturer or its service agent or a
similar qualified person in order to avoid a hazard. Indoor
use only.
To prevent electric shock, match wide blade of plug to
wide slot, fully insert.
CAUTION! ImpOrTANT
sAfeTy INsTrUCTIONs:
This portable lamp has a polarized plug (one blade is wider
than the other) as a feature to reduce the risk of electric
shock. This plug will fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet, reverse the plug. If
it still does not fit, contact a qualified electrician. Never use
with an extension cord unless plug can be fully inserted.
Do not alter the plug.
20w Marietta Floor Lamp
bulbs are not
®
Marietta Floor lamp!
®
®
tubes (Style Number SB20-M). Use of other
If the external flexible cable or
Need help?
Do you have a question about the VisionSaver Plus Marietta and is the answer not in the manual?
Questions and answers