American Megatrends Super Voyager LPX User Manual page 168

Power Management Setup,
Continued
Power Supply Timeout
This option can be used to control a Green PC-capable power supply
(such as the SENSTRON GP2-4200F power supply). When this option
is set to Enabled, the power supply can be placed in Green PC poser
savings mode when the timeout period specified in the System Event
Timer option expires via the J1 output. The settings are Disabled or
Enabled. The Optimal and Fail-Safe default settings are Disabled.
Before this option can be set to Enabled, the System Event Timer
option setting must be a value between 1 Min and 15 Min. and the Stop
Clock Mode option must be set to Enabled.
Power supplies that support a timeout feature provide a cable with a two-
pin berg header, often called the Auxiliary Power Connector. Usually,
the black wire is Ground and the Green wire is the active signal. Connect
the black wire to Pin 1 of J1. Connect the Green wire to Pin 2 of J1 on
the motherboard.
If the VGA monitor does not support DPMS (the VESA Display Power
Management Specification), you can connect the VGA monitor to the
auxiliary output of a Green PC power supply. When the length of time
specified in the System Event Timer option time period has expired,
AMIBIOS turns off any device connected to the auxiliary connector.
Green PC power supplies usually identify the power connectors that can
be turned off in Green PC mode.
This option is only supported if an S-Series Intel CPU is installed on the
motherboard.
Chapter 6 AMIBIOS Setup
162