Advertisement
11. With a small common screwdriver, press the entire plate
towards the edge of the developer roller cavity, and lift up. The
plate should come loose.
13. Remove the developer roller. Be careful not to damage or
lose the flat washers on the roller.
3232 West El Segundo Blvd., Hawthorne, California 90250 USA
© 2009 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only. UniNet Imaging does not warrant downloaded information.
SAMSUNG ML 2250 • CARTRIDGE REMANUFACTURING INSTRUCTIONS
•
Ph +1 424 675 3300
12. Gently pry out the roller plate from the cartridge. The foam
seal, and possibly a plastic flat washer will come out with it. Be
careful not to damage the foam seal, or loose the flat washer.
14. It is highly recommended that the doctor blade be cleaned.
Failure to do so will cause streaking. The doctor blade can be
cleaned with out removing it. Dampen a cotton swab with alco-
hol, and clean the blade. Be careful not to press too hard and
damage the blade. If the blade has a heavy buildup of toner on
it, clean it with acetone, and then alcohol. Removing the blade
is difficult because of the foam seals attached. If the seals are
torn, the cartridge will leak. That is why we do not recommend
it. Once replacement doctor blades are available, they will
have to come with replacement foam.
•
Fx +1 424 675 3400
•
techsupport@uninetimaging.com
•
www.uninetimaging.com
Advertisement
