Advertisement
23. Install the right side end cap, and 4 screws. Make sure the
PCR fits correctly in its holder, and all the gears are aligned.
25. Replace the chip. Make sure the chip you install is the cor-
rect one for the machine it is to be installed in. New reset
boxes are now available that can change the personality of the
chip across the full line. This will enable you to test the car-
tridge in your test machine, and than change the chip to work
in your customer's machine if different.
3232 West El Segundo Blvd., Hawthorne, California 90250 USA
© 2009 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only. UniNet Imaging does not warrant downloaded information.
SAMSUNG ML 2250 • CARTRIDGE REMANUFACTURING INSTRUCTIONS
•
Ph +1 424 675 3300
24. Fill the hopper with the appropriate amount of toner.
This can also be done through the fill plug, but the fill plug
tends to leak and will probably have to be sealed with silicon.
•
Fx +1 424 675 3400
•
techsupport@uninetimaging.com
•
www.uninetimaging.com
Advertisement
